Скоба - незаменимая оснастка при подъемно-строительных работах. Скобу можно использовать для соединения подъемных шкивов и фиксированных строп. Это легкий и гибкий инструмент для подключения, который широко используется.Кандалыдужки можно разделить на дужки и U-образные дужки в зависимости от их внешнего вида. По назначению бывают: цепные скобы, якорные скобы и плавающие скобы.
(1) Цепькандалы is a кандалы used to connect the anchor chain. When in use, the horizontal bolt should be upward, and the horizontal bolt should be round to prevent it from rotating in the bolt hole and increase its strength. When using, first take out the horizontal bolt of the кандалы, put the U-shaped buckle into the anchor chain ring to be connected, and then connect the horizontal bolt in series to an anchor chain ring above. In order to prevent the horizontal bolt from coming out, there is an oblique hole at each of the two ends of the horizontal bolt and the U-shaped buckle for driving the brake oblique pin. In order to prevent the oblique pin from coming out, a green lead seal should be inserted into the cavity left at the pin hole. Before the oblique pin is inserted into the pin hole, calcium-based grease should be applied to prevent rust.
(2) Якорь кандалы is the кандалы used to connect the anchor chain and the sinker, and the method of use is the same as the chain кандалы.
(3) The floating кандалы is the кандалы used to connect the floating body and the anchor chain, and the method of use is the same as the chain кандалы.
